"Diagnosed dryer, noticed slight squeak on initial start up. Checked rollers and found a couple that were worn and covered in lint. Cleaned up inside unit and installed dryer repair kit. Tested unit, unit no longer squeaking on start up.

"Replaced worn suspension. Ran unit through diagnostics mode to check for error codes and check all components working to spec. No error codes stored, all components working to spec. Unit working as designed."

Installed new drain pump and ran calibration test on unit. Ran unit through diagnostics mode to check for error codes. No error codes present in memory. All components working to spec. Ran unit through a quick cycle to ensure unit is working properly out of diagnostics mode. Unit working as designed.

"Placed unit in diagnostics mode and found multiple codes for out of balance, suds lock abatement, and water pressure sensor. Ran unit through diagnostics mode and all components working to spec. Observed excessive suds in the basket during diagnostics mode. Checked suspension is good. Until working as designed."

"Installed new pcb and user interface. Ran unit through calibration cycle. Tested unit, unit working as designed."