"2-2-23 (JN) replaced part and tested, unit is now operating properly."

3 HOURS Drain pump Recirculating pump Gearcase Basket ; ordrng 1 W10915703 (Recirculating pump) and 1 W10876600 (Drain pump) and 1 W10752187 (Screw(bolt)) and 1 W10902814 (Washplate) and 1 W10811960 (Basket) and 1 W10734521 (Slider) and 1 W10754448 (Clutch) and 1 W11032711 (Washer)

"2-2-23 (JN) replaced boards and tested, unit is operating properly."

2 TECHS 2 HOURS Needs parts listed ; ordrng 1 W10752187 (Screw(bolt)) and 1 W10902814 (Washplate) and 1 W10752719 (Basket) and 1 W11454734 (Gearcase) and 1 W10721967 (Cam Kit) and 1 W11219115 (Tub)

2-2-23 (JN) called customer to inform I was in route and customer advised me that some one was there working on the unit.

"Description; while in rinse cycle unit gives 1E error code and stops. The filter in the inlet water valve were clogged up 90% with sediment. Cleaned them, tested, unit working to spec. Collected $150 total, check #3977"

2/2 LG//. Installed Parts tested OK

2/2 LG// installed part tested okay

2/2 LG// unit is having issue washing testing found water valve not opened all the way. Opened unit tested okay for 40 mins. Testing found soap dispenser not activating if customer continues to have issue replace dispenser

2/2 LG// testing found error code 72. Contacted John from GE TECHLine found bad encoder board will have to replace customer approved TOTAL DUE 294.59; ordrng 1 WB27X24643 (Board)

2/2 LG// parts collected

"2-2-23 (JN) replaced parts listed and tested, unit is operating properly."

2/2 LG// contacted sue from FIDELITY he stated unit was getting submitted for replacement. Autho LM65165

"Description; unit not turning on. Tested,unit turned on, drained and called for water right away. No water connections in store to test with water. Unit working to spec."

Replaced 20 amp fuse. Unit installation is tight due to tile being done too high. At least one tile has n right has a void behind and risk of break is high. Unit to be reinstalled by contractor.1259.99100.90$235.89

Control just clicks and will not go into diag. Needs part listed.; ordrng 1 W11498797 (Control)

"Installing new IM, tested, working to spec. ; dspstn on spec-tagged invntry: 1 5304532555 ICE MAKER"

"Description; unit leaves stained clothes sometimes. Drum and agitator are good no damage or anything that could stain clothes, advised customer to wash dispenser due to having lots of residue from soap and softener, advised customer to only use 2 table spoons of detergent. Unit has a bent lid at the hinges not closing all the way down. Ordering parts and rescheduling. ; ordrng 1 203575W (Lid) and 1 36513 (Left hinge) and 1 36437 (Right hinge)"

Needs part listed ; ordrng 1 DC97-21472H (Assy housing drawer)

Door is loose during spin. More parts needed.; ordrng 1 DC34-00028A (Lock) and 1 DC66-00375A (Lever(strike))

More parts needed ; ordrng 1 DC33-01010D (Cold valve) and 1 DC33-01011C (Hot valve) and 1 DC92-02394T (Assy module PBA) and 1 DC97-22838A (Assy detergent module)

Unit needs revised upper rack.; ordrng 1 W11501779 (Tiered rack)

Needs parts listed ; ordrng 1 00778926 (Facial) and 1 00752315 (Buttons RH) and 1 0062843 (Button Start Resume)

"2-1-22 (JN) replaced water inlet valve and tested, unit is operating properly."

2-1-23 (JN) upper and lower racks are not operating properly/ staying in place(falling).; ordrng 1 Upperrackadjustmentkit (Upper rack adjustment kit) and 1 W10822166 (Rail) and 1 W10822165 (Rail) and 1 WPW10473807 (Carrage) and 1 WPW10473809 (Carrage)

2/1 LG// installed part tested okay

"Installed new compressor, went to purge system with nitrogen, when dark green gunk followed by black burnt gunk started to come out, tried to clean out with nitrogen for a couple of minutes but it wasnt clearing up contamination, the smell was very strong. Called tech line to report and advise, unit will put up for review. File # 86098263 ; dspstn on spec-tagged invntry: 1 5304529284 COMPRESSOR and 1 A19676501 FILTER"

2-1-23 (JN) found display To not Display full numerals also main board issue. Unit Starts to feel after spin has completed; ordrng 1 W11352122 (Board) and 1 W11318817 (Console assembly / board)

2/1 LG// cleare multiple obstructions tested okay no parts needed

2-1-23 (JN) tested unit several times without any leakage. Customer stated the unit dripped water once and has not occurred again. Unit is operating properly.

"Description; not cooling. Units defrost timer stuck, needed to be advanced manually. Sealed system working to spec. Timer needs to be replaced. ; ordrng 1 5304526183 (Defrost timer)"

"Description; not drying. The igniter is OL, needs to be replaced. ; ordrng 1 5318EL3001A (Igniter)"

"Description; heating problem. Tested, all components came back good, unit working to spec."

Replaced faulty parts

2/1 LG// installed part tested okay

"Description; unit not draining or spinning. I made unit drain but Motor was ceased up and so was the gear case, outer basket is damaged due to the friction from the spin basket spinning when it broke off the gear case shaft. Wash plate is also stuck on gear case shaft. The control board has buttons that are stuck and unresponsive. ; ordrng 1 AGZ72909711 (Wash plate) and 1 AEN74532607 (Gear case) and 1 AJB73816031 (Stator) and 1 AHL73894509 (Rotor) and 1 MEL62741701 (Inner hub) and 1 AJQ74774301 (Inner tub) and 1 FAF30369201 (Washer) and 1 4020FA4208J (Hub nut) and 1 4040FA4045C (Washer) and 1 5006EA3009B (Cap) and 1 EBR86498801 (Control board)"

Blower defective; binding.; ordrng 1 12031271 (Blower)

2-1-23 (JN) found thermostat on heater housing to read (OL) when tested. Unit not heating.; ordrng 1 D518542 (Thermal fuse)

"Description; broken panel, replaced, tested, working to spec."

"2-1-23 (JN) found no frost pattern and compressor is running. Bad compressor.Quote as follows part, tax , labor $850.00 customer declined repair."

2-1-23 (JN) bake / broil not igniting. No power to either ignitor.; ordrng 1 5304518023 (Board) and 1 318578506 (High limit) and 1 5304514198 (Cut off)

"Description; making noises when washing. Unit has a bad transmission, leaked all the oil out damaging the motor. Wash plate is stuck. ; ordrng 1 W11172199 (Spin basket) and 1 W10919191 (Wash plate) and 1 W10528947 (Drive block) and 1 W11454372 (Gear case) and 1 W10721967 (Drive pulley) and 1 W11239857 (Belt)"

Zacarias @ BSHG TL020123 11:37am Z.A.C.Unit tested fine

2/1 LG// Compressor not running right replace tested oaky

2/1 LG//Found Styrofoam piece cutting between tub and base couldnt takeoff needs two man job No parts needed as of now; saved tckt

"Installing new magnetron, tested, working to spec."

FTST 86096854Unit must be on dedicated non GFCI GFIC 15 amp circuit. Needs part listed.; ordrng 1 5304533259 (Board assy)

2-1-23 (JN) Replaced thermostat and tested unit is operating properly at this time